Search found 2510 matches

by Eric1
Mon Nov 19, 2018 10:25 am
Forum: Power Boats
Topic: C19 Question
Replies: 6
Views: 108

Re: C19 Question

Have they considered the CX19?
by Eric1
Mon Nov 19, 2018 10:17 am
Forum: Power Boats
Topic: C17 in the bayou
Replies: 171
Views: 3953

Re: C17 in the bayou

I faired before the flip. I think it is easier to doe while the bottom is up. I also painted prior to flipping with the intent of doing final paint later.
by Eric1
Mon Nov 19, 2018 10:07 am
Forum: Power Boats
Topic: Eric's C21
Replies: 2547
Views: 79609

Re: Eric's C21

I think you guys are right about the build. I guess I'm going to build a center console since I primarily intend to fish. It was a little warmer in the shop at 68 degrees. I could feel the difference in the epoxy during layup too. I touched up the corners and fillets, then I laid my glass. It went d...
by Eric1
Mon Nov 19, 2018 6:55 am
Forum: Builder's Power Boats
Topic: ST21 Hybrid Powered "SKINNYDIP" Noosa Australia
Replies: 3561
Views: 179400

Re: ST21 Hybrid Powered "SKINNYDIP" Noosa Australia

All is right with the world again. Cheers to you my Friend!
by Eric1
Mon Nov 19, 2018 6:49 am
Forum: Power Boats
Topic: Eric's C21
Replies: 2547
Views: 79609

Re: Eric's C21

BB Sig wrote:
Sun Nov 18, 2018 7:12 pm


What is that specialized tool in the bottom of the picture? Just curious... :doh:
It's a cup holder for the epoxy.
by Eric1
Sat Nov 17, 2018 4:21 pm
Forum: Power Boats
Topic: Eric's C21
Replies: 2547
Views: 79609

Re: Eric's C21

I can't wait until you get to a next step. What is going on under the sole? Couple of gas tanks, pvc tubing for needed wires and hoses, considering a strainer / pickup for bait tank wash down, bilge pump etc. I must admit I have poorly planned past this part of the build. I am back to thinking cent...
by Eric1
Sat Nov 17, 2018 4:07 pm
Forum: Power Boats
Topic: My cx 25
Replies: 181
Views: 7854

Re: My cx 25

Amen! Frames are not fun!
by Eric1
Fri Nov 16, 2018 9:23 pm
Forum: Builder's Power Boats
Topic: FS 17 - Raised Sheer
Replies: 186
Views: 10598

Re: FS 17 - Raised Sheer

Very clean work! Good Job!
by Eric1
Fri Nov 16, 2018 12:39 pm
Forum: Power Boats
Topic: Eric's C21
Replies: 2547
Views: 79609

Re: Eric's C21

piperdown wrote:
Fri Nov 16, 2018 11:38 am
Good progress Eric :D

Are you just taping the frame and stringer seams and then coating with epoxy? Or are they going to be covered in glass?
Just tape and coat, though I've given thought to glass in a few areas. We'll see.

Thanks Y'all. :D
by Eric1
Fri Nov 16, 2018 11:24 am
Forum: Power Boats
Topic: LM18 in Perry, GA
Replies: 164
Views: 5011

Re: LM18 in Perry, GA

Nice work!!