Search found 2917 matches

by topwater
Mon Jun 24, 2019 7:55 am
Forum: Builder's Power Boats
Topic: DE 24ish
Replies: 52
Views: 1068

Re: DE 24ish

It will also give you a good flat surface for your spray rails.
by topwater
Fri Jun 21, 2019 7:28 am
Forum: Builder's Power Boats
Topic: PH18 Build in North Dallas (PH20)
Replies: 3449
Views: 227804

Re: PH18 Build in North Dallas (PH20)

The new G2 115 is the same engine they use for the 150 , so if you are going to carry the weight you can have more HP.
Pretty impressive engine for only 3 cylinders with great MPG especially at lower RPMs .
by topwater
Tue Jun 18, 2019 7:03 am
Forum: Builder's Power Boats
Topic: ST21 Hybrid Powered "SKINNYDIP" Noosa Australia
Replies: 4359
Views: 230279

Re: ST21 Hybrid Powered "SKINNYDIP" Noosa Australia

You are going to have to put on sunglasses every time you walk into the shop :!:
I likey 8)
by topwater
Mon Jun 17, 2019 7:09 am
Forum: Builder's Power Boats
Topic: DE 24ish
Replies: 52
Views: 1068

Re: DE 24ish

That brings back some memories :!:
by topwater
Mon Jun 17, 2019 7:00 am
Forum: Anything else and for sale. . .
Topic: Anyone Fishing?
Replies: 4575
Views: 281002

Re: Anyone Fishing?

Don't worry it will lay down :lol:
by topwater
Wed Jun 12, 2019 7:27 am
Forum: Sail Boats
Topic: AD16? hardware & rigging for mod chinese rig per plans
Replies: 14
Views: 313

Re: AD16? hardware & rigging for mod chinese rig per plans

The boat in the pic is a Goat island skiff.
by topwater
Tue Jun 11, 2019 7:43 am
Forum: Builder's Power Boats
Topic: GT27 Build (Wes K)
Replies: 260
Views: 9208

Re: GT27 Build (Wes K)

Thats how i did mine 8)
by topwater
Tue Jun 11, 2019 7:41 am
Forum: Cracker Larry's Corner: Boat Repair and Rebuild Support
Topic: Hydra Sport 1800CC Transom Rebuild
Replies: 13
Views: 276

Re: Hydra Sport 1800CC Transom Rebuild

I would give yourself more room , you will find stringer damage at the transom and will need the room to fix.
by topwater
Tue Jun 11, 2019 7:29 am
Forum: Power Boats
Topic: Lm18 madison wi transom questions
Replies: 6
Views: 178

Re: Lm18 madison wi transom questions

For the transom pry the panels apart enough to get the glue in all along the the joint and the use a couple of screws to hold them in place . You should only need 1 or 2 per side do not over tighten. Same for the bottom panels , you will have to cut that first zip tie closest to the transom to get e...