Sharkbait PG20

To help other builders, please list the boat you are building in the Thread Subject -- and to conserve space, please limit your posting to one thread per boat.

Please feel free to use the gallery to display multiple images of your progress.
sharkbait2576
Frequent Poster
Frequent Poster
Posts: 99
Joined: Sun Oct 21, 2018 9:58 am
Location: San Antone/Bahamas

Re: Sharkbait PG20

Post by sharkbait2576 » Wed Jun 10, 2020 12:36 am

Forgot...I cut out the section on the transom where the motor goes too.



FluidDynamic
Active Poster
Active Poster
Posts: 336
Joined: Sun Dec 30, 2018 9:09 pm
Location: Spanish Fort, AL

Re: Sharkbait PG20

Post by FluidDynamic » Wed Jun 10, 2020 4:31 pm

Did you manage to do all of that wet on wet? i tried, but ran out of time and had to sand.

sharkbait2576
Frequent Poster
Frequent Poster
Posts: 99
Joined: Sun Oct 21, 2018 9:58 am
Location: San Antone/Bahamas

Re: Sharkbait PG20

Post by sharkbait2576 » Sat Jun 13, 2020 5:58 pm

No way. I got the filets and seams done wet on wet. Then did one side of the cloth. Ran out and am on a trip. I got one side done. Will order some cloth and do the other side a week from now. Gonna be I. The Bahamas for July and August so try to finish in September.

sharkbait2576
Frequent Poster
Frequent Poster
Posts: 99
Joined: Sun Oct 21, 2018 9:58 am
Location: San Antone/Bahamas

Re: Sharkbait PG20

Post by sharkbait2576 » Sat Jun 27, 2020 9:35 pm

Heading to the Bahamas for a couple months to spear fish and surf. Will crank up the factory when I get back.

Post Reply

Who is online

Users browsing this forum: No registered users and 8 guests