Page 3 of 3

Re: SK14 in N Florida

Posted: Sat Sep 28, 2019 11:40 pm
by Explorer 19TV
Here she is today :D
9DB0C644-FA3A-4ECC-A662-BB9E09E711A7.jpeg
F392D763-1771-491F-A584-63AFEAA5B95B.jpeg

Re: SK14 in N Florida

Posted: Sat Oct 12, 2019 12:52 pm
by Reklus
Thats a clean lookin ride you have there!

Re: SK14 in N Florida

Posted: Fri Oct 18, 2019 8:48 am
by fotofinish
Sorry, been away from the forum for a while. That is a really nice looking SK!

Re: SK14 in N Florida

Posted: Fri Oct 18, 2019 11:49 am
by Capt UB
Explorer 19TV wrote:
Sat Sep 28, 2019 11:40 pm
Here she is today :D
9DB0C644-FA3A-4ECC-A662-BB9E09E711A7.jpegF392D763-1771-491F-A584-63AFEAA5B95B.jpeg


I like that grab bar... Where did it come from?

Re: SK14 in N Florida

Posted: Wed Jan 22, 2020 7:56 pm
by Explorer 19TV
Sorry guys been around the world and back with my job.

I built it, cost me about $30 bucks

Re: SK14 in N Florida

Posted: Fri Jul 10, 2020 9:30 am
by fotofinish
After a few months when I was unable to work on the boat, I have finally been able to get back to it. Got some primer on the top side this week and it feels like a milestone. Looks like I will need very little additional fairing. My motor clamp needs a thicker transom than the 3/4 inch. Does anyone have any design ideas for making it look nice and making it functional. I am thinking of using ash for the pad since its pretty hard. I have seen one with recesses for the motor clamp pads to land in for increased security. I am thinking of making the bottom edge mirror the scupper top curve but with a longer radius. Any thoughts or suggestions?
app.php/gallery/image/7007/source

Re: SK14 in N Florida

Posted: Fri Jul 10, 2020 10:28 am
by BrianC
fotofinish wrote:
Fri Jul 10, 2020 9:30 am
...My motor clamp needs a thicker transom than the 3/4 inch. Does anyone have any design ideas for making it look nice and making it functional....
Here is what I did:
Image

And here are the details on my build thread:
viewtopic.php?f=14&t=61727&start=60#p395420

Re: SK14 in N Florida

Posted: Fri Jul 10, 2020 4:41 pm
by fotofinish
Thanks, that's nice looking work. Did you use a hole saw for the clamp pad holes. I enjoyed your launch video as well.

Re: SK14 in N Florida

Posted: Fri Jul 10, 2020 5:36 pm
by BrianC
fotofinish wrote:
Fri Jul 10, 2020 4:41 pm
Thanks, that's nice looking work. Did you use a hole saw for the clamp pad holes. I enjoyed your launch video as well.
Thanks, and yes, I used a hole saw on the top layer of ply.