FS14 The filler between the wire ties........

Power Boats only. Please include the boat type in your question.
User avatar
Capt UB
Active Poster
Active Poster
Posts: 274
Joined: Mon Jan 03, 2011 7:12 pm
Location: DeLand Fl
Location: DeLand, Florida
Contact:

Re: FS14 The filler between the wire ties........

Post by Capt UB » Mon Oct 02, 2017 12:28 pm

Eric1 wrote:
Mon Oct 02, 2017 11:48 am
Hi Bob, Just thought I'd let you know I didn't use tape when filling holes or filling the seams. I went underneath my build last week and start taking down the excess. Started with a small sander, PITA and dusty. Then I tried a small 1/2" chisel. Man that is the ticket! You can lay the chisel down close and tap it with a hammer. All the filler cut clean and flush without dust! :D
I use chisels for removing epoxy runs, have a nice set just for that. I thought about just squeezing in filler, then use a tongue depressor from inside to clean it up there, harder to sand the inside seam then the outside!!!


I'm always lost when building a boat, it's when the boat is in the water, I know my way.

1970? 13' Canvas on frame canoe
2017 Bateau FS14, starting build Oct 2017.
2017 Bateau NC16, starting soon.

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests