EMC paint

technical support and information on EMC topcoats and coatings
Post Reply
User avatar
topwater
* Bateau Builder - Expert *
* Bateau Builder - Expert *
Posts: 2856
Joined: Tue Oct 30, 2007 6:27 pm
Location: Florida
Location: Florida

EMC paint

Post by topwater » Fri Jan 16, 2015 8:43 am

How much flex can this paint take before cracking or checking ? I would like to paint the pilot house top before
installing but when i do i will have to flex it about 3/8" downward on the frames. Do you think the paint will take
it or should i paint after install ?


Novi 23 finally launched !

User avatar
tech_support
Very Active Poster
Very Active Poster
Posts: 12319
Joined: Wed Dec 31, 1969 7:00 pm
Location: Vero Beach, FL
Contact:

Re: EMC paint

Post by tech_support » Fri Jan 16, 2015 9:23 am

3/8" over the whole top is not much, but I would paint after you bending. I would probably primer before bending also

User avatar
topwater
* Bateau Builder - Expert *
* Bateau Builder - Expert *
Posts: 2856
Joined: Tue Oct 30, 2007 6:27 pm
Location: Florida
Location: Florida

Re: EMC paint

Post by topwater » Fri Jan 16, 2015 9:58 am

Thanks Joel, its in primer now. I guess i will have to paint it from a ladder :(
Novi 23 finally launched !

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest