Hand held drum sander?

Post any and all methods for doing things here, if you think you have a good method, that you don't see most builders using

User avatar
Active Poster
Active Poster
Posts: 366
Joined: Thu Sep 14, 2017 7:50 am
Location: Houston Texas

Re: Hand held drum sander?

Post by OrangeQuest » Fri Feb 09, 2018 7:47 pm

I seen that picture but that is not so portable. And if you use a longer bolt then you could put a inline skate wheel (a handle) on the drum end to help apply pressure and better control of the angle. OR...

If you use 5/16" round stock you could have a smooth stud to chuck up in the drill, weld a nut on the stock, flat washer, drum, another flat washer, thread nut, skate wheel and a lock nut or jam nut.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest