Has anyone tried this C&c router?

Post any and all methods for doing things here, if you think you have a good method, that you don't see most builders using
Post Reply
Masoric
Frequent Poster
Frequent Poster
Posts: 10
Joined: Tue Jan 21, 2020 8:51 am

Has anyone tried this C&c router?

Post by Masoric » Sat Feb 01, 2020 8:02 am

Has anyone tried this $500 4x8 c&c router?

Seems like it has a small margin of error compared to professional units. But for the main construction method here that might not be an issue.

https://www.maslowcnc.com/



fallguy1000
Very Active Poster
Very Active Poster
Posts: 4263
Joined: Tue Jan 12, 2010 12:25 am

Re: Has anyone tried this C&c router?

Post by fallguy1000 » Sat Feb 01, 2020 9:26 am

I saw it, but at the end of the day, it seemed easier to draw lines and run a router by hand.
My boat build is here -------->

viewtopic.php?f=12&t=62495

Jaysen
* Bateau Builder *
* Bateau Builder *
Posts: 4361
Joined: Wed Aug 05, 2015 7:59 am
Location: St Helena Island, SC

Re: Has anyone tried this C&c router?

Post by Jaysen » Sat Feb 01, 2020 10:55 am

Know a guy that has one. The problem for us would be the edge cuts. It tends to get “wobbly” in the edges. Other than that he loves it.

His solution to the edge issue is to just stop his plans 1” from the edge.
Jaysen wrote:
Mon Apr 29, 2019 3:44 pm
I tried to say something but God thought I was wrong and filled my mouth with saltwater. I kept my pie hole shut after that.

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest