Moonfish Plans questions for Jacques

Sail Boats 15' and up. Please include the boat type in your question.
Post Reply
Jeff
Site Admin
Site Admin
Posts: 6326
Joined: Fri Apr 29, 2016 12:17 pm
Location: Vero Beach

Moonfish Plans questions for Jacques

Post by Jeff » Thu Apr 30, 2020 8:43 am

These questions arrived via email: "Dear BBC-Team, I recently bought your Moonfish plan, meanwhile collected all the stuff I need for building the boat and will now, during the upcoming weekend, start with the first steps. When looking into your plans in detail I was not able to figure out if the deck and bottom plywood will cover the cutting edges of the side panels or if it will be the other way round. Looking at the transom measurements and comparing them with the measurements of deck and side-panel at transom, it seems to me, that the thickness of the plywood is somewhere missing. Can you tell me, if this is by purpose, because at the end you planned such a big radius to be sanded (down to cleats ore EP-filets) ore if I should add 6mm on each longitudinal side of deck and bottom? (No problem, my plywood sheets are wide enough). Looking forward to your answer! Best regards,"
Jeff



User avatar
jacquesmm
Site Admin
Site Admin
Posts: 27333
Joined: Wed Aug 14, 2002 1:00 am
Location: Florida USA
Contact:

Re: Moonfish Plans questions for Jacques

Post by jacquesmm » Thu Apr 30, 2020 12:16 pm

The panels meet at their inside edges.
Jacques Mertens - Designer
http://bateau.com

Post Reply

Who is online

Users browsing this forum: No registered users and 2 guests