Stringer pads

Please see our tutorials and FAQ before posting.
Post Reply
fallguy1000
Very Active Poster
Very Active Poster
Posts: 1231
Joined: Tue Jan 12, 2010 12:25 am

Stringer pads

Post by fallguy1000 » Thu Feb 15, 2018 10:12 pm

In one of the bateau foam tutorials it shows a foam pad with 45s on each side under a stringer. Is that pad glued down with epoxy to the hull and then the stringer glued to the pad or is it just floating there say with hotglue and then the tabs hold it all in place?

Thanks.


My boat build is here -------->

viewtopic.php?f=12&t=62495

User avatar
jacquesmm
Site Admin
Site Admin
Posts: 25904
Joined: Wed Aug 14, 2002 1:00 am
Location: Florida USA
Contact:

Re: Stringer pads

Post by jacquesmm » Fri Feb 16, 2018 10:41 am

No air gaps = everything filled with epoxy putty.
Never any air, that's the principle. How you keep it in place while you add the resin is up to you. Hot glue gun is fine, weights or clamps are good too.
Jacques Mertens - Designer
http://bateau.com

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest